How to apply pre-pasted wallpaper
Matching printed wallpaper patterns
Make sure you match the patterns on all the wallpaper.
VIDEO
PHOTOS
PREPARATION
- a. Brush b. Wallpaper smoother c. Roller
d. Spatula e. Sponge f. Bucket g. Cutter
h. Scissors i. Measuring tape j. Cloth
k. Caulk (if necessary)
STEP1: Measure the size of the wall.
Measure the size of the wall.
Measure the size of the wall and decide how much wallpaper is required. Make sure to add another 5cm on each end to cut off afterward.
STEP2: Cut the wallpaper.
Spread out the wallpaper on the floor.
Spread out the wallpaper on the floor, pattern side up.
Check arrows and marks.
Check arrows to show the ceiling side and marks to show where to match the patterns.
Cut the wallpaper.
Make sure to match the patterns of the wallpaper on the ceiling side, add an extra 5cm to the top and bottom ends and cut the wallpaper.
Fold the wallpaper.
Once the cutting is done, peel off the back film and fold in the wallpaper.
STEP3: Hang the first sheet of wallpaper.
Mark the wall.
Start measuring the size of the wallpaper width and mark the wall for a base line.
Draw a base line.
Draw a base line using a plumb hanging from the mark.
Hang the first sheet of wallpaper.
Hang the first sheet of wallpaper along the base line.
Smooth out.
Make sure it's hung just along the base line, smooth out the air from the left of the wall to the right and from the center to the outside using a smoother.
Cut the ends.
Cut the top, bottom and the right ends of the wallpaper.
Wipe off the extra glue.
Wipe off the extra glue well using a wet sponge and peel off any tape on the left end of the wallpaper.
STEP4: Hang the rest of wallpaper.
Hang the second sheet of wallpaper.
Hang the second sheet of wallpaper matching the patterns with the first one.
Smooth out.
Once you have decided on the position, smooth the surface from the right of the wall to the left using a brush.
Cut the ends.
Cut the top and bottom ends of the wallpaper.
How to cut along the seam.
Place a steel smoother along the line 5mm away from the edge of selvage, and cut off two sheets of wallpaper together.
Smooth out.
Smooth the surface over the seam using a roller.
Repeat the same process.
Repeat the same process until you hang the last sheet of wallpaper.
STEP5: Hang the last sheet of wallpaper.
Measure the rest of wall.
Measure the rest of wall.
Cut the wallpaper.
Cut 5cm further than the width of the wall.
Hang the last sheet of wallpaper.
Hang the last sheet of wallpaper matching the pattern of the sheet next to it.
finished
